8/21/2023 0 Comments Ecu edc15 vin and immo offIn attachment flash read by mpps and eeprom ori and eeprom immo off. I think the immo off has to be done in the flash: 29F800BT ? And if I check the immo status on channel 91 I see that immo is adapted. or possible to desolder eeprom 24c04 and read it with eeprom programmer and then with by example a edc 15 immo software to put off the dump that you extract with the programmer and then resolder on the ecu. Now I but the engine ecu back to car and after that I see that still fault code in the engine 7978 - Engine Start Blocked by Immobilizer. hi friend i did it with a k can commander by obd on edc 15 vm+ work perfect. After writing the immo off in eeprom I connected the computer on the table and I see in the immo is disabled (status 1). I have tested immo off on the 24C04(in attachment). And the injector pump is from similar car and the spare part code is the same. Audi A4 2.5 (BDG) 2006, not Start after injection pump replacement(starts and then dies)and fault code in the engine 17978 - Engine Start Blocked by ImmobilizerĬhange VP44, and not posible adapt chanel 50, pin ecu login ok, but not posible adapt VP44, "system not in order".
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |